0.75 × 0.25 in labels on a roll
Tiny component label roll, for thermal label printers
Tiny component label roll for label printers: each label is ¾ in wide and ¼ in long (19.05 mm × 6.35 mm).
Use this paper
Part of this page could not load, so the test page button is missing. Reload the page to try again.
Free for up to 100 labels a month. No account needed. A test page is never counted.
Measurements
| Measurement | Inches | Millimeters |
|---|---|---|
| Label width | ¾ in | 19.05 mm |
| Label length | ¼ in | 6.35 mm |
| Corner radius | 1/16 in | 1.59 mm |
| Labels | One label per page: the page size in the print window is the label size | |
What fits on this label
- A QR code up to 0.25 in (6.4 mm) square fits, its blank border included. For a short web address such as https://www.encodelabel.com (27 characters) each square of the code is then about 0.17 mm: too small to scan reliably, so a QR code is a poor fit for this label. Longer text means smaller squares. QR code labels
- A UPC-A barcode inside the retail size range doesn’t fit: the smallest, 80%, is 29.8 mm wide with its blank margins. It can still be printed at about 51% (19 mm wide). Handheld scanners often read that; a shop checkout may not. On a label printer every bar is rounded to whole printer dots, which can make it print smaller than this: the print step shows the real size. UPC-A barcodes
- A line of 10 pt text doesn’t fit with room to spare: use smaller type, or a code without text.
Worked out from the measurements: advice, not a rule. The tools make any size and show the real printed size as you go. Barcode and QR code sizes
Printing tips for this kind of paper
- A roll printer treats each label as a page. In the printer’s own settings on your computer, set the paper size to the label size, then pick the same size in the print window. Thermal label printers
- After loading a new roll, run the printer’s label calibration so it finds the gaps between labels. The printer’s manual says how. Thermal label printers
- Print one label before a long run and check that it sits in the middle of the label. If it doesn’t, check the label size in both places and run the calibration again. Thermal label printers
Related sizes
All label paper- 1 × 0.5 in labels on a roll A near size
- 23 × 23 mm labels on a roll, compatible with Brother® DK-1221 A near size
- 25 × 25 mm labels on a roll A near size
EncodeLabel isn’t made, tested or endorsed by the makers of Brother® labels. Brother® is a trademark of its owner. The product numbers only show which sheets and rolls a size is made to fit. About brand names